Mounting the Miata gauge cluster in the wood dashboard with a metal insert to improve the aesthetic of the stock gauges.
Lexan gauge cover.
Pattern making for trunk lid.
Hatch made from ABS plastic with metal hinge.
Started connecting the wiring harness up to the car. Thanks to the guy i bought the motor from for labeling most of the important connection points. We were able to connect most stuff up including motor, instrument panel, transmission, fuel pump, ignition, battery, and other bits. My steering signal and lighting assembly seems to be different from the harness and will require some re-wiring to make use of the signal and lighting switches. Will have to locate and attach the thread the harness through the chassis in its final resting place later.
Next to get the fuel supply, cooling supply and exhaust sorted so that we can get the engine running.
Cut circular holes in the firewall to mount the factory wiring harness seals and allow the harness to pass through. Detached and re-attached the necessary engine wiring to thread it through the hole. Factory seal/gasket fits well into holes.
April 10, 2016 – Update – Started thinning out the wiring harness to try to cut down on the bulk. Lighting and engine running so excess wires can be weeded out. Removed radio, hvac, headlight retractor and door wiring to start.
Prior to performing the first drive, the brakes and clutch were made operational. For the brakes, the lines were installed, filled with fluid and bled. Started bleeding at the furthest brake caliper and made our way up to the closest to the master cylinder, then repeated until there were no more air bubbles. Luckily none of the bleeder screws/valves on the calipers were seized shut. A Wilwood brake proportioning valve was installed in the line that I purchased from Flyin’ Miata (https://www.flyinmiata.com/complete-adjustable-brake-proportioning-kit.html)
For the clutch, the existing slave cylinder was seized and had to be replaced with new one I picked up from a local auto parts store. Once replaced, the master was filled with fluid and line was bled.
Plugged it all in, fuel, vacuum hoses etc.